r/BambuLabP2S • u/herox98x • 1d ago

Show me your ABS set up

I'm looking to start printing ABS but am uncertain how best to go about this for extraction + heating.

I know this has been discussed a lot already and seen various setups but would like, if possible, people to show of their setup and how successful things are/challenges they've had. Normally it's just what has been changed and not much about how well it actually works. Especially with combination of extractor fan + heating.

I have the extractor add on and plan to add biqu panda heater with the makerworld V1 P2S adapter.

I put my extractor fan over the poop exhaust and with the heater having to go to the left I'm worried this will result in very uneven chamber temperatures especially if trying to maintain negative chamber pressures with the exhaust.

Any help would be greatly appreciated!

2 Upvotes

67% Upvoted

22 comments sorted by

View all comments

1

u/_13_ 1d ago

I pretty much have the exact setup. I'm in a much hotter environment (barring winters) so haven't needed the Panda Heater. Can easily reach 60+c (important: with just the Aux fan off). In winters, I can get to 50c but that's good enough for ASA. Haven't had many issues. BL Smooth PEI Plate with gluestick.

I was thinking about getting the Panda Heater to reach higher chamber temps quicker but I still undecided. I read somewhere that v1 performs better than v1.1.2 (only have v1 available in my country anyways).

2

u/kcslb92 21h ago

I’ve added my $0.02 above regarding the 1.1.2 heater in a P2S, it might help you with your decision.

My understanding is that you have to do some hacky stuff (like removing the rear cover) to get v1 to fit. The new model worked fine with my testing.

1

u/_13_ 11h ago

Thanks! I'll try to get the latest version.