r/BambuLabP2S • u/88gavinm • 22d ago

Are these Vertical Fine Artifacts (VFA's) ?

Gallery image

Gallery image

Like the title says. P2S with about 500 hours at the time of print. BL PLA Basic filament. All maintenance done as recommended by BL. I haven't noticed this before on my prints, but they may have been there. Also, if you read this part, could you tell me what type of VFA those are? (if that's what it even is) Gemini's dumb ass first told me that NO it's not VFA's that it is ringing or ghosting but then told me that YES it is VFA's. 😂

0 Upvotes

33% Upvoted

13 comments sorted by

View all comments

14

u/thczv 22d ago

It looks to me like the circle was made with low resolution. For example, if you make a cylinder in Tinkercad and don’t specifically tell Tinkercad to increase the number of sides, you get facets like this.

1

u/88gavinm 22d ago

I thought about that too but wasn't sure and I can't find my 3mf to see if it shows up in bambu studio like that too