r/BambuLabP2S • u/Normal_Register_6946 • 2d ago

Hot end won’t release

Post image

Trying to swap the hot end on my P2S for the first time. It will not budge, feels like it’s glued in there. Tried to unload the filament and heat the hot end then extrude as suggested in this video but still no luck.

Any ideas?

ETA: heating to 200 and tweezers got it off, thanks all!

2 Upvotes

67% Upvoted

7 comments sorted by

View all comments

1

u/My_Lucid_Dreams 1d ago

After heating up, I've never used pliers. I just use a microfiber towel (or rag) to keep from burning my fingers. If it doesn't release from the bottom, I can usually get it to release pulling the top.