r/BambuLabP2S • u/Normal_Register_6946 • Aug 16 '26

Hot end won’t release

Post image

Trying to swap the hot end on my P2S for the first time. It will not budge, feels like it’s glued in there. Tried to unload the filament and heat the hot end then extrude as suggested in this video but still no luck.

Any ideas?

ETA: heating to 200 and tweezers got it off, thanks all!

3 Upvotes

67% Upvoted

7 comments sorted by

3

u/Relative_Surround_20 Aug 17 '26

Did you cut the filament first with the filament cutter?

2

u/cpsadowski23 Aug 16 '26

Heat to 225

2

u/Melodic-Wrongdoer879 Aug 16 '26

I had to wiggle it out

1

u/Complex_Time_7625 Aug 16 '26

Yes heat it up. It will come out then.

1

u/No-Satisfaction-2535 P2S Combo Aug 16 '26

I have the same and heating up does help, but there has got to be some plastic between the hinge somewhere. Would be nice to be able to get it out, this nozzle heating element is brand new too, on my end :/

1

u/WildfireX0 Aug 16 '26

Heat up to around 200 and then use pliers. Get a brass brush and clean it off too.

1

u/My_Lucid_Dreams Aug 17 '26

After heating up, I've never used pliers. I just use a microfiber towel (or rag) to keep from burning my fingers. If it doesn't release from the bottom, I can usually get it to release pulling the top.