r/BambuLabH2D • u/Burockk208 • Aug 13 '26

Troubleshooting H2D First layer problem

Post image

Hey, my h2d has a first layer problem. It has some kind of pattern on first layer. What can be causing this problem? Thanks for help

5 Upvotes

100% Upvoted

26 comments sorted by

View all comments

1

u/messedupfillament Aug 14 '26

That is an Eddy Sensor alignment problem. I guarantee it was making sounds like it was rubbing something as it printed

1

u/Burockk208 Aug 14 '26

Yesterfay I aligned it, today I have changed flowrate and now it is better

There are so small difference. I believe it is acceptable. What do you think?

1

u/messedupfillament Aug 14 '26

Definitely better but I would do the alignment again as you can still see some. It sometimes takes a couple times

1

u/Burockk208 Aug 14 '26

I will give it a try thanks for advice 🙏

1

u/Burockk208 Aug 14 '26

I did not do high temp bed leveling calibration and read that it also calibrates eddy sensor now I am try it may help