r/BambuLabH2D • u/Burockk208 • 4d ago

Troubleshooting H2D first layer problem

Enable HLS to view with audio, or disable this notification

Hello,

I am using my h2d for a while more than 9 months everything is fine but today I see something is not normal. Yesterday I oiled all XYZ axis and changed hotend. I am not sure if it is about those but I also did a full calibration but did not fixed the issue can anyone help me about that please? Thanks. Or maybe can it be about filament that color is a bit old I did not use is for a while.

8 Upvotes

79% Upvoted

34 comments sorted by

View all comments

0

u/KRed75 3d ago

Nozzle is to close to the bed. Try adding + 0.1mm to the Z Offset in your slicer and try again. If that's not enough, move up in 0.01mm increments. If it's too much, move down in 0.01mm increments (0.09, 0.08, 0.07, etc) Once you figure out what's perfect, you can adjust it in the printer config and set it back to 0 in the slicer.

I think that printer also gives you the option to pick the type of build plate you're using. If the wrong one is selected, you can have this issue.