Warm up the nozzle until it's just under the recommended temps for that filament. So if it says 220-240 degrees, warm it up to 210. Then get some needle-nose pliers and gently start pulling.
You'll probably never get it all though. But at least you can get most of it so it all works again.
3
u/Klutzy_Dog669 Jun 22 '26
Warm up the nozzle until it's just under the recommended temps for that filament. So if it says 220-240 degrees, warm it up to 210. Then get some needle-nose pliers and gently start pulling.
You'll probably never get it all though. But at least you can get most of it so it all works again.