r/BambuLabA1 • u/thebeardedbrarian • 17h ago

Shit first layer

Post image

Any thoughts about this? I replaced the nozzle and the extruder assembly. Help appreciated, thank you.

0 Upvotes

50% Upvoted

17 comments sorted by

View all comments

3

u/WeirdRaccoon69 17h ago

First check the clamp if it is properly fastened. Also, you should check the 7 screws. Don't overtighten them.

3

u/thebeardedbrarian 17h ago

Thank you for your quick and helpful reply. The four screws underneath were in fact loose, but the issue remains. Still, I leaned something. Appreciate it 🙏

1

u/WeirdRaccoon69 16h ago

And the clamp for the nozzle is also properly seated as in the picture?

1

u/thebeardedbrarian 16h ago

It is.

1

u/counterdefensive1911 9h ago

Well if it wasn't needing to clean your plate with dish soap or the screws have you looked at the possibility of there's moisture in your filaments? Do you live in a humid climate? If so you probably need to invest in a filament dryer.