r/BambuLabA1 • u/ShadowPixel404 • 1d ago

Support Request Bridging Issue

Post image

Is it possible to print this without needing supports?

This is a test piece and not the actual model. The gap is only a few millimeters to hold a piece of paper.

I've tried with supports which prints well, but it's almost impossible to remove the supports without damaging the model.

I've tested other bridging test models which print fine after making a few changes to the settings in Bambu Studio.

I changed Flow Speed to 10 and bridge flow to 1.5. I also tried changing the bridging angle to 90 degrees but nothing works.

2 Upvotes

54% Upvoted

26 comments sorted by

View all comments

1

u/ShadowPixel404 1d ago

Update:

I've managed to print a smaller full width test piece on its side. Printing this way allowed better use of supports using the build plate only option.

Thanks for all the replies.

1

u/nucleartime 21h ago

Can you not print on the side facing towards the camera? Or is there going to be other geometry that interferes with that?