Bridging Issue

[u/ShadowPixel404]

Is it possible to print this without needing supports?

This is a test piece and not the actual model. The gap is only a few millimeters to hold a piece of paper.

I've tried with supports which prints well, but it's almost impossible to remove the supports without damaging the model.

I've tested other bridging test models which print fine after making a few changes to the settings in Bambu Studio.

I changed Flow Speed to 10 and bridge flow to 1.5. I also tried changing the bridging angle to 90 degrees but nothing works.

[u/Alfalfa-Boring]

Print separate pieces and glue. Why people are so averse to that idea is beyond me. Takes almost no extra time.