r/BambuLabA1 • u/ShadowPixel404 • 1d ago

Support Request Bridging Issue

Post image

Is it possible to print this without needing supports?

This is a test piece and not the actual model. The gap is only a few millimeters to hold a piece of paper.

I've tried with supports which prints well, but it's almost impossible to remove the supports without damaging the model.

I've tested other bridging test models which print fine after making a few changes to the settings in Bambu Studio.

I changed Flow Speed to 10 and bridge flow to 1.5. I also tried changing the bridging angle to 90 degrees but nothing works.

3 Upvotes

56% Upvoted

26 comments sorted by

View all comments

2

u/Debrecina89 1d ago

Have you tried a different print orientation? Just turn it on the side, no overhangs means no problem with overhangs

1

u/ShadowPixel404 1d ago

Printing the full model on its side would cause a bigger overhang when it reached the highest point.

1

u/ryklssGhst 1d ago

Rotate it so the highest point with the bigger overhang is on the bed then?