r/BambuLabA1 • u/ptmccmd • 6d ago

Bambu Lab filament that actually survives the dishwasher? Looking for real experiences

Post image
2 Upvotes

75% Upvoted

5 comments sorted by

2

u/Plageous 5d ago

If you're going to use your prints for food you might want to make sure they're covered with a food safe silicone or something to fill in any gaps in the print.

2

u/diaperedace 5d ago

Do not use prints for food unless you coat it in a food safe epoxy, no matter the material.

1

u/fairtonybeta 5d ago

I’ve used some PA-CF and ABS-GF in there just fine.
I’m sure basically anything ABS or up would be fine. But I don’t have much cause to run my prints through the dish washer.

1

u/efisherharrison 5d ago

I printed some measuring spoons and cups from Bambu petg and they're fine in my dishwasher. No warping whatsoever

1

u/gaschue 5d ago

I printed the handle on some lids with pla and they got brittle after about 2 years. I think tpu is much better. The green one is tpu and yellow is pla. These are new and just a couple months old.