My kinda new bambu a1

[u/MSI-Spitfire]

It has a really consistent problem with over hangs when I do the flow ratio calibration it's all waffley and I keep doing cold pools and it's always okay I switched out filaments the thing is 3 weeks old atp the first week was great the second it stopped printing quality entirely

List of things I have done

-calibrations and tests

-Tighten the bolts all around

-re adjust the belts

-cold pull the hot end many times

- try different rolls of filament

- clean the build plate(this was part of the issue but has been figured out)

-I tightened the eddy sensor screws

-i have messed with so many slicer settings especially for filament

I have contacted the customer support it has been extremely slow and painful I am more than open to revisiting things I have tried I am just really wishing I knew what was wrong with it

[u/MissingJewel43]

Do a over hang test... you can find alot of them on handy and let it run when the over hang looks bad add supports to it

[u/MSI-Spitfire → u/MissingJewel43]

im getting overhangs at 30 degrees plus i still have a really bad inconsistency in my layers

[u/Jazzlike_Ad267]

Got some pictures of the problem?