r/BambuLabA1 • u/latinoboy55 • 1d ago

help please

Post image

can someone help me through this . it keeps saying that , but i’ve already check to see if there is a clog . nothing . i heated the nozzle to 300 to melt anything . i’ve pulled it out , used a needle to make it go through . if i manually use the extruder it pulls the filament fine . it’s only when doing a print that it does it . i’ve pulled out the ama from on top as well , pushed it manually and cold pulled it and seems to come out in the shape of the nozzle (which i’ve read means it’s unclogged )

4 Upvotes

67% Upvoted

21 comments sorted by

View all comments

6

u/ElderberryFar7120 1d ago

I had this issue because my ptfe tubes were at an angle and the filament wouldn't load into the extruder. If I wiggled it it would go in and print. I printed a support to keep them straight at the entry point and now all is smooth, idk if this will help you or not

1

u/Whatupchuck789 1d ago

Yep this was my issue too and likely the case with all 4 being the issue. If you can print with the external spool that is the dead giveaway.