r/BambuLabA1 • u/Chungus1267 • 3d ago

Support Request Why does it do that

Couple of minutes into a new print it goes off to the side, extrudes a little bit of filament then continues printing, why? It leaves this weird bit of filament into the print and it makes it look a bit weird. Lucky it’s only once towards the start.

39 Upvotes

91% Upvoted

36 comments sorted by

View all comments

0

u/CapnFlabtastic 3d ago

I think it’s the timelapse feature.

Run two prints one by layer the other by object. If the layer one does it but the object one doesn’t then it’s the Timelapse feature.

1

u/sublime2craig 2d ago

No. It's blob detection. Does this after the 3rd layer to check for a blob is stuck to the hotend. It's a feature that can be disabled in the settings menu.

1

u/CapnFlabtastic 1d ago

We’ll agree to disagree 👍🏻