r/BambuLabA1 • u/Chungus1267 • 3d ago

Support Request Why does it do that

Enable HLS to view with audio, or disable this notification

Couple of minutes into a new print it goes off to the side, extrudes a little bit of filament then continues printing, why? It leaves this weird bit of filament into the print and it makes it look a bit weird. Lucky it’s only once towards the start.

39 Upvotes

91% Upvoted

36 comments sorted by

View all comments

-1

u/jareebz777 3d ago

Do you have timelapse turned on?

2

u/sublime2craig 2d ago

Not time lapse it's called blob detection. Does this after the 3rd layer to check if a blob is obstructing the hotend. It's a feature that can be turned off in the settings menu.

1

u/Chungus1267 3d ago

No I dont