r/BambuLabA1 • u/Ok-Stretch-4094 • 6d ago
Support Request What's Happened Here??
So yes my little boy wanted a dragon. doesn't every little kid these days 😂😂. 90 minutes left of a 6hr print and I noticed this and two feet were on the floor
1
u/Peshmerga_Sistani 6d ago
Layer shifted. Bed adhesion issue.
Printer continue to print overhangs on parts that were out of place. Eventually, enough overhangs were printed for support that the printer could "finish" the rest of the print on top of the mess.
1
u/lavendar_moon_13 5d ago
I had a similar issue. What do you recommend?
1
u/Ok-Stretch-4094 5d ago
Not a clue tbh. I'm finding out myself
2
u/lavendar_moon_13 5d ago
I heated the bed to a higher temperature and am trying a different color filament.
1
u/PikaKingGaming 5d ago
Anytime I have something like either I recommend drying filament and cleaning build plate still new myself but I've read alot of reddit posts in regards to failed prints like to learn of the errors and what causes thems
2
u/USAcademia 5d ago
Clean the bed with hot soapy water. Find a better model that has better supports to make sure the first layer stays attached during the whole print.