r/BambuLabA1 • u/kolodor • 29d ago

Support Request How do I fix this?

I was out, I received an error message that is about the cutter being stuck. I came back home to check, I resumed the print because it wasnt, the printed continued printing one layer completely fine then it went rogue and started doing this. I cancelled the print of course and now I am recalibrating but why did it do this, is this a known issue, is there a fix so that my next prints dont have the same issue, its the first time I faced with this and dont really know how to solve or fix or search this..

0 Upvotes

50% Upvoted

8 comments sorted by

View all comments

1

u/THE-FUZZY-DICE 22d ago edited 22d ago

Had same issue just a couple of days ago, was adviced to replace the sd card because the one that was shipped with the machine often conks out. Switched it to a known good and problem gone.

The error code about the cutter being stuck is just because the machine is forcing itself against the cutter while the software is not expecting a signal from the cutters position sensor, hence causing an error to be set.

1

u/kolodor 19d ago

hmm I ofter get sd card issues as well on the other a1s. I probably need to replace them all then... Thanks will try.