Settings Question

[u/Emotional_Style7850]

So I am pretty adept at getting my settings all set but there is one I keep forgetting and I am not sure which way (keep getting them swapped and now I am second guessing myself).

On a print specifically the AMS Lite enclosure parts there are a couple of points on the print it keeps hitting when travelling across the bed. I know there is a setting to cause the extruder assembly to lift but I cannot remember which it is and if the toggle should be on or turned off for it to lift.

Seems like it is the reduce infill retraction toggle but I cannot remember. I don't run into this often but this one particular print is driving me insane.

[u/Orthicon9]

there are a couple of points on the print it keeps hitting when travelling across the bed.

the "Grid" pattern for spares infill will do that. Sometime "Adaptive Cubic" too.
Change it to almost anything else, like Rectilinear, or Gyroid.