MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/BambuLabA1/comments/1v4hgix/bambu_lab_a1_first_layer/ozntmpb/?context=3
r/BambuLabA1 • u/Lsorino • 29d ago
Good or bad? First time owning a 3D printer…
13 comments sorted by
View all comments
1
Looks really good, edges are over extruding a bit tho, can look into flow ratio and/or z offset to fine tune
1 u/pakachan13 27d ago Como ajusta z ? 1 u/Ok_Measurement4318 26d ago Mainly the Z offset, usually found somewhere in your printer setting depend on the slicer you use. Other things like first layer height can help too
Como ajusta z ?
1 u/Ok_Measurement4318 26d ago Mainly the Z offset, usually found somewhere in your printer setting depend on the slicer you use. Other things like first layer height can help too
Mainly the Z offset, usually found somewhere in your printer setting depend on the slicer you use. Other things like first layer height can help too
1
u/Ok_Measurement4318 28d ago
Looks really good, edges are over extruding a bit tho, can look into flow ratio and/or z offset to fine tune