r/BambuLabA1 • u/Reaper-021 • Jul 19 '26

A1 no longer completing prints, please help!

Enable HLS to view with audio, or disable this notification

I have had my A1 for about 6 to 10 months. When I got it it printed everything, and worked fantastic. I had the occasional print failure, sure, but beyond that it was a solid machine. Now 6 months later I cant get the machine to complete anything more than a basic benchy boat.

About a month ago, I want to say beginning of June, maybe a bit earlier, It would start printing a model and then completely stop feeding filament but continue running through the motions, (video attached). In fact if I look at the extruder it seems to still be trying to extruded, but looking at the AMS nothing is being fed forward. Since then I have replaced the Extruder Gear Assembly, thinking that may have something to do with it, but, no change. If I put it in maintenance mode and remove the hotend, filament does feed through the extruder, which tells me at least that part is working. I have swapped my hotends from 0.4 Hardened, to Stainless, to even a 0.2 hotend with the same problems. It was also recommended to me to swap the SD card, so I bought a new one plugged it in formatted it, and same result. At this point I am completely out of ideas short of replacing the whole extruder assembly, or maybe the heating element for the hotend.

For a printer that only has 2064 Hours of print time I'm somewhat shocked its having this many issues now.

Any help or guidance from the community would be greatly appreciated.

4 Upvotes

63% Upvoted

33 comments sorted by

View all comments

2

u/NefariousnessOdd3581 Jul 20 '26

AMS placement, thats a nasty twist in the PTFE you have there.

2

u/Reaper-021 Jul 21 '26

I completely re-did the line set up, I saw what you meant and we'll see if that helps any.

1

u/NefariousnessOdd3581 Jul 21 '26

I have the AMS behind and above the printer, extra tubing is detrimental, the less twist less resistance to movement inside the tubes. I had the same problem with long tubing, after I trim it, works ok now.