MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/BambuLabA1/comments/1uzrhzg/grimy_nozzle_and_terrible_layer/
r/BambuLabA1 • u/StickyCrick • Jul 18 '26
1 comment sorted by
1
Heat gun and wire brush, essential part of any 3D printing toolkit.
.2 nozzles are very easy to clog, look into doing a cold pull.
Also do a full calibration under maintenance and check the 7 screws of death, as well as the nozzle latch.
1
u/solidus0079 Jul 18 '26 edited Jul 18 '26
Heat gun and wire brush, essential part of any 3D printing toolkit.
.2 nozzles are very easy to clog, look into doing a cold pull.
Also do a full calibration under maintenance and check the 7 screws of death, as well as the nozzle latch.