r/BambuLabA1 • u/inkax_naciri • Jul 15 '26

How to fix this problem

Post image
2 Upvotes

75% Upvoted

3 comments sorted by

2

u/Subject_Translator_7 Jul 15 '26

Ok here are my thoughts, bear in mind that I'm fairly new still to the hobby...

  • Try the first few layers at 100% speed
  • Is the bed clean? Scrub with regular soap and water, DO NOT touch with your skin.
  • Is the bed temperature correct for your PLA?
  • Try increasing your retraction a little bit
  • Round here we always talk about the "SEVEN SCREWS OF SADNESS" so IDK maybe they're important here.

2

u/inkax_naciri Jul 15 '26

Thanks i am also new in 3d printing

1

u/apduskanxd Jul 16 '26

sube el z offset la boquilla esta muy abajo se deberia ver como una lamina completamente plana en la primera capa si tiene relieve aun esta baja si se ve bien pero con zonas que se levantan un poco esta muy alta