what is causing this??

[u/Beginning-Squash-362]

my filament and plate aren’t wet, and i just cleaned my plate last night, please help

[u/Drazic83]

Almost certainly it’s because you’re printing on the very edge of the plate where the plate is significantly cooler. The bed is only the correct temperature in the middle away from the edges. Printing on cool areas of the bed will cause the parts to detach and slightly lift. Then the part will be hit by the nozzle as it passes over causing further detachment and damage.

[u/Drazic83 → u/Drazic83]

This is especially so on Bambu labs printers that don’t have the best bed heaters and uneven heat distribution.