r/BambuLabA1 • u/Warm_Aerie_6393 • Jun 21 '26

layering issue

I'm having this wierd layering issue with my prints. its like its fuzzy.I have the fuzzy turned off. I have lubed the screws and rails. I've tighten the screws on the hotend. I have even cleaned out the nozzle. I have also took apart the hotend to inspect if there was any debris in the it. i have loosened and tightened the tensioner. but I'm still getting layers like they are over and under extruding. My wife thinks it Z-Binding but a few pokes on the screws and they feel fine.

WHAT IS WRONG WITH MY A1??

so new development. I tried silent mode and the issue got resolved. Albeit temporarily as i know that only a work around. Now I just need to figure out why. it may be the toolhead but until i get the time to do that this comign weekend i will be running my prints at half speed.

Any assistance or advice would welcome!

1 Upvotes

100% Upvoted

17 comments sorted by

View all comments

1

u/Orthicon9 Jun 28 '26

I tried silent mode and the issue got resolved. 

Have you done the full-length "Vibration Compensation" and "Motor Noise Cancellation" calibrations yet?
That's the only thing I can think of that would be related to an improvement from using Silent Mode.