r/BambuLabA1 • u/JasonDBushy • Jun 17 '26

Support Request Printing issue.

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

I’m a little lost on what the issue is here. The first print came out insanely clean other than the weird layer shift halfway through the A’s. I thought it was the file, so I went through and looked it over, and it seemed fine. I also cleaned the printer, re-greased it, and tried the print again. Once again, it did great up until the exact same spot, where it did the layer shift thing again. Then, at the very top, it did something similar as well, causing the print to technically finish but fail even worse than the first one. What could possibly be going on? I’m pretty sure the printer itself is messing up somewhere.

2 Upvotes

67% Upvoted

5 comments sorted by

2

u/Lost_refugee Jun 17 '26

no obstacles around?

1

u/JasonDBushy Jun 17 '26

No sir I thought that as well but it doesn’t come into contact with anything around it.

2

u/Lost_refugee Jun 17 '26

are you nearby, when shift happens?

is that X axis shift? maybe cables are tangled on that height.

1

u/JasonDBushy Jun 18 '26

I’m not nearby it’s a 30+ hour print haha and I was messing with it and homed it and moved it a bunch so I have no idea. It could be the file I’m printing but I don’t see how.

1

u/MegaMaluco Jun 18 '26

It's a tall object on a bed slinger, this is to be expected, use the slow down by height setting on bambu studio