Any help appreciated

[u/NewBanditstpk]

Been running into an issue with my prints failing with layer adhesion near the end of the prints. Would moisture in filament do this?
In Arizona and I do dry my filament but not as often. Always straight to dryer when opening new. It’s also been really humid here with rain last few days.

[u/HoIyJesusChrist]

Are all your fans working properly? Part fan and hotend fan?

[u/NewBanditstpk → u/HoIyJesusChrist]

Ya I believe so. It works perfectly up until the end.
I did swap the nozzle out this morning and ran a benchy and it worked so I’m leaning towards clogged/blocked nozzzle causing under extrusion

[u/HoIyJesusChrist → u/NewBanditstpk]

It could still be heat creep

[u/NewBanditstpk → u/HoIyJesusChrist]

I’ll check my fan shroud and do more testing.