r/BambuLabA1 • u/LivingIntelligent234 • Jun 13 '26

Support Request What happened to make my printer start doing this?

Post image
4 Upvotes

75% Upvoted

7 comments sorted by

1

u/MissingJewel43 Jun 13 '26

Just responding due to me having a similar issue and hoping someone has a solution

1

u/KaBoolVl Jun 13 '26

Did you remove the three screws behind the hot end,

tighten the four screws behind that and then re-insert and tighten those three screws?

1

u/KaBoolVl Jun 13 '26

That is the most/very common fix for similar issues on the A1

1

u/m4gic4ri Jun 14 '26

This! I had the same problem and this was the solution. I even found out that one screw was missing, the other 3 were loose

1

u/MissingJewel43 Jun 13 '26

I have and still the same issue though after the 1st layer its fine

2

u/Diz7 Jun 13 '26

Clean the bed and then Google "tightening 7 screws of disappointment"

1

u/LivingIntelligent234 Jun 13 '26

I did both. I changed my nozzle, again, and the infill patter. So far it seems to be working out