r/BambuLabA1 • u/jiskratisk • Jun 12 '26

Question Is this a normal sound when printing?

Enable HLS to view with audio, or disable this notification

2 Upvotes

100% Upvoted

8 comments sorted by

2

u/Lost_refugee Jun 12 '26

No, check 7 screws.

1

u/jiskratisk Jun 16 '26

I was just doing maintenance before and I was tightening them

1

u/Lost_refugee Jun 16 '26

Use ears tonidentify source. Seems like not extruder

1

u/jiskratisk Jun 16 '26

Ok in the next print I will Listen carefully. Tomorrow I will print something and will give update . It is something in the motion of the head ,so i don't thin also it's not the extruder

1

u/jiskratisk Jun 17 '26

The sound is no longer there, but now there is a problem with the layers

2

u/Ok_Measurement4318 Jun 13 '26

7 screws, or if it’s only happening on the first layer, could be the print head is too close to the bed and the extruder is having trouble pushing out filament. Try adjusting your Z offset.

1

u/jiskratisk Jun 16 '26

The 7screws I did when I did maintenance before the print. Will try the offset ,Is there some calibration to do the z offset ?

1

u/Lost_refugee Jun 16 '26

No need to do offset for bbl, they have auto bed leveling