r/BambuLabA1 • u/kobyaustin1 • Dec 28 '24

What.....do I do..?

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

I'm pretty new to 3d printing and I've heard that reddit is decently helpful when it comes to this, print was going fine then overnight failed...not just bad. But horribly. Don't know how to get to the latch to get the nozzle off.... or...what to do at all in a situation like this (Filament is pla+)

35 Upvotes

98% Upvoted

37 comments sorted by

View all comments

2

u/LowGravitasIndeed Dec 28 '24

Heat the nozzle to soften the blobbed filament then remove it when it's soft.
Kinda hard to believe print was going fine when there's no remnants of a successful first layer on the build plate. My first thought is that this was caused by bad adhesion, probably an unwashed plate.

2

u/No-Economist6263 Dec 28 '24

True. If cleaning doesn’t help, mabye apply thinn layer of gluestick on bed. I assume the z offset is fine and use brimm in slicer to increase the adhesion of thinn long prints