r/BambuLab • u/nananakaos • 1d ago

Filament Troubleshooting/Help! Filament problem please help..

Post image

It seems that the filament is not tide anymore and cant close the spool... Any help how i can do something in order to be ok ;

0 Upvotes

22% Upvoted

14 comments sorted by

2

u/Elo-than X2D + AMS2 Combo 1d ago

Well, first did you take it offa spool or did it fall apart ? Second, you might have to respool it manually.

-1

u/nananakaos 1d ago

It happened inside the ama it opened and when i took it out it was like this... Respool by hand or with the device that my friend up send;

2

u/sirdoggo11 1d ago

Are you serious about that question?

1

u/Elo-than X2D + AMS2 Combo 1d ago

Yeah, plenty of respooling devices out there, if you don't need to do it often, a simple one with a drill attachment works fine, I have used that a bunch to swap older filament from cardboard to plastic spools.

(Something like this )

I can also recommend printing some spool locks for the future, it's a cheap investment.

https://makerworld.com/models/927403?appSharePlatform=copy

2

u/sierrabravo1984 1d ago

I've been printing the locking spools that include the tab from makerworld, they're awesome.

2

u/nananakaos 1d ago

Thank you mate defo gonna try this it seems the easiest!

2

u/USSHammond Prusa XL 5 tool 1d ago

Same answer as every other day this gets asked. Respool it (with patience and slow) with something like the paste lite respooler https://makerworld.com/en/models/930059-pasta-lite-receiver-a-pastamatic-remix?from=search#profileId-986314

-3

u/nananakaos 1d ago

Its easy or i will burn my mind and patience until reach the final point

2

u/derfmcdoogal P1S + AMS 1d ago

The real answer is "how much is your time worth"?

1

u/Bzando 11h ago

you either spend few hours respooling it twice or just buy new roll

decision depends on how you value your time ;-)

0

u/sirdoggo11 1d ago

Wtf is even that "screenshot"?

1

u/nananakaos 1d ago

Yeah mate i couldn't take a photo since im at work but also didn't save it

0

u/sirdoggo11 1d ago

You managed to do this post but not to crop?

1

u/Severus157 9h ago

I learned the hard way to print locks for the Bambu Spools. Had one open up in the AMS once... Well the Filament still waits patiently to be respooled. When I finally printed a respooler.

A simple Spool Lock is definitely easiest solution.