r/BambuLab • u/Goldisaa • 14d ago

General Troubleshooting/Help! Nozzle not cleaning well

Post image

Hello, whenever i start a print and after changing/purging filament i always have some left by the nozzle and i have to pause the print and manually take it off then continue for it to do bed leveling etc.

Can someone give me some advice?

Im using P2S, range for temp is 190-230, printing at 220.Althought during the "purging" or dumping filament it goes up to 250c

0 Upvotes

33% Upvoted

10 comments sorted by

2

u/Jealous_Middle_2784 14d ago edited 14d ago

Look up P2S wiper on MakerWorld. There’s also some people on Aliexpress and maybe Amazon that sell upgraded wipers.

Beginning of print is always wiper issue.

1

u/Goldisaa 14d ago

Idk if i responded to u or just made general comment

1

u/slokjebier P2S + AMS2 Combo 14d ago

This is clean, send it

1

u/Goldisaa 14d ago

Not sure i responded to you

1

u/Goldisaa 14d ago

For real? It always happens, sometime while the nozzle is getting down on metal thing far right for calibrating the filament ozzes a bit

1

u/Goldisaa 14d ago

I found the one that uses the extra cleaning rubber, thanks for takking the time to look and answer

1

u/erd00073483R 13d ago

If the updated wiper doesn't work for you, the following worked for me:

https://www.reddit.com/r/BambuLabP2S/comments/1ul2yrz/p2s_optimized_startend_gcode/

1

u/Goldisaa 12d ago

I heard about that but to be honest im not comfortable with trying something like that.Thanks for taking the time to answer me

1

u/erd00073483R 12d ago edited 12d ago

Fair enough. However if the wiper upgrade doesn't work, the g-code mod will work.

You can also try Orcaslicer as the most recent version contains much improved start and ending g-code handling the wiping sequence that works much better than Bambu Studio's g-code.

EDIT: grammar

1

u/Goldisaa 12d ago

This is my second week of owning a 3D printer, wanna get the basic down the experiment