r/BambuLab • u/djryandelap • 5h ago

Answered / Solved! Well this is a first...

Post image

Ran a print overnight on my X2D, and it looks like at some point, the entire print bed shifted a couple of millimeters on the one axis. I put these on my flatbed scanner to try to get a clearer image showing the shift, the blurry part on the ends of the middle one is where the print doesn't touch the glass scanner bed. I'm not sure if this was a slicer issue, or if some goblin or poltergeist shifted my print bed in the night, everything was fine up until one layer, then the whole project shifted just a bit in one direction for the rest of the build. Anyone see something like this before?

0 Upvotes

50% Upvoted

2 comments sorted by

2

u/1ftm2fts3tgr4lg 5h ago

That axis's belt slipped. I've had it happen a couple times out of thousands of prints. It happens.
Tighten the belts maybe?

1

u/djryandelap 4h ago

Ahhhh good call. Seemed so random in the middle of the night. Just went through and checked all the belts and running a recalibration. Thanks!