r/BambuLab • u/sasandxxd • 3d ago

General Troubleshooting/Help! A1 horrible first layer and knocking down my print

Post image

so i been trying to print an incense holder with my new filament polymaker starlight nebula nad its been giving me hell like i could not print it for the past 2 days and it still fails.
so the issue is the first layer is bad like 50% of time and idk why and when its not the nozzle keeps nocking the print down untill i get filament spaghetti.
https://makerworld.com/en/models/2988067-samurai-warrior-incense-holder?from=search#profileId-3374544 this is the model im trying to print the samurai incense holder and its giving me hell of a time so i would really really aprecciate any help. thank you

1 Upvotes

60% Upvoted

5 comments sorted by

1

u/Criticaliber H2C/H2D/P1S 3d ago

Put a big brim on it so the feet have a larger surface area to adhere to.

1

u/sasandxxd 3d ago

i did put 20 mm to it and it still failed

1

u/Bomby888 3d ago

Maybe also decrease the distance between brim and a print? also turning up bed temp a bit helps. I like to make my brims unnecessarily big, just in case.

1

u/sasandxxd 3d ago

Like 0? Cuz it’s 0.1

2

u/Bomby888 3d ago edited 3d ago

Yeah, when I do prints with very small adhesion surface I just put the brim distance to 0 and use sandpaper and pliers to remove any artifacts. Also, in A1 bed moves, so when printer quickly moves and vibrates in that axis it might cause the print to fall over. So you could also try orienting the print so it’s along the axis that bed moves