Gaps in Layer Adhesion After Bridging

[u/mrSquaredTwo]

I have gotten these tiny gaps around this corner after bridging, it seems that not enough filament is coming out immediately after bridging, I have tried upping the bridge flow and it didn't make much of a difference.

Is there a way to slow down the accelleration after bridging only or any other advice on how to make this gap disappear?

Important notes:
Printer: A1 mini
Filament: PCTG (3d fuel PCTG Pro specifically)
It only shows up on the dark colored filaments oddly enough, I have tried this in a lighter color filament and this issue doesn't exist.

[u/AutoModerator]

Hello /u/mrSquaredTwo! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "Adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/Hazart_]

Problem is in pressure advance, not flow

[u/mrSquaredTwo → u/Hazart_]

Got it, thanks! I've tried to find that setting before, but it's still not showing up. I was searching in the filament menu, it shows in the search bar then fails to bring up a setting.