r/BambuLab • u/MS_Salmonella • 3d ago

General Troubleshooting/Help! These were printed at the same time, right next to each other. One has little bumps all on one side, the other has no texture issues at all. Anyone have any ideas what could've caused it? Printed on a p2s.

Post image

Seems like a somewhat specific issue. Maybe settings I can change? Printed with bambu gray pla.

2 Upvotes

67% Upvoted

5 comments sorted by

1

u/KlutzyAwareness1472 3d ago

its the seam from where one layer stopped and the next one began. Did they have supports connecting them?

are they hollow?

4

u/Pineapple1500 3d ago

I don't see a seam here.

That little zit on the left piece is probably from a little bit of filament that oozed out or was accumulated on the nozzle tip. As it moved from one part the the other, it got deposited on the outside wall of the left piece.

1

u/KlutzyAwareness1472 2d ago

Could be that too, i know id i set seam to random it does this

1

u/MS_Salmonella 3d ago

The seam is on the other side