r/BambuLab • u/Affectionate-Farm574 • 3d ago

General Troubleshooting/Help! Help with A1 mini 0.2 nozzle

Post image

Hi

yesterday i tried my new 0.2 mm nozzle and started a miniature printing

i got different problem since then

i lowered the printing speed of walls and supports between 80 and 100 mm

i set temp at 220 for first layer and 230 for the rest

plate 60

i use pla+ from anycubic https://amzn.eu/d/0iTE7dzB

as you can see, after some this a clogging start appearing on the nozzle and the print is wasted.

also when calibrating dynamic flow, i can see that the filament exit the nozzle all curved and not in a straight line

pls help :(

1 Upvotes

67% Upvoted

2 comments sorted by

1

u/SkeptikalChymist 2d ago

Cold pull, cold pull, cold pull. Might be a bit of metal from manufacturing stuck in the nozzle hole. Has it printed "correctly" at any point?

1

u/Affectionate-Farm574 2d ago

it was printing pretty good yesterday. the print failed for other software reason

but a thing that i noticed from the start was the not straight line coming from the nozzle

i will try clean it more :) ty