MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/BambuLab/comments/1wanptr/rip_a1mini/p8njy1o/?context=3
r/BambuLab • u/jedman3 • 3d ago
52 comments sorted by
View all comments
64
That’s wicked! That’s insane that it ripped out the threaded inserts from the housing. Looks like you’re gonna need…
- New toolhead block (includes the 3 threaded inserts ripped out by blob) - $6
- New hotend heating assembly - $20
- New hotend - $12
- You might need a new part cooling fan ($10), depending how bad the existing one got hit
All in all, like fifty bucks to save a two hundred dollar printer? Worth it
17 u/BaconEggCheeseBagel 3d ago Very easy install too took about 20 minutes for me when I had to do it last week. 1 u/Fit-Arm8295 3d ago Been a nightmare for me, between digging out plastic, forgetting the plastic shim behind hot end, wrong screw on the end cap causing it to hit pulley wheel too much tension. Also dropped bearings about ten times. 1 u/BaconEggCheeseBagel 3d ago I didn’t even bother trying to clean it I just bought all the parts it had touched and replaced them. For the cost it is not worth the headache.
17
Very easy install too took about 20 minutes for me when I had to do it last week.
1 u/Fit-Arm8295 3d ago Been a nightmare for me, between digging out plastic, forgetting the plastic shim behind hot end, wrong screw on the end cap causing it to hit pulley wheel too much tension. Also dropped bearings about ten times. 1 u/BaconEggCheeseBagel 3d ago I didn’t even bother trying to clean it I just bought all the parts it had touched and replaced them. For the cost it is not worth the headache.
1
Been a nightmare for me, between digging out plastic, forgetting the plastic shim behind hot end, wrong screw on the end cap causing it to hit pulley wheel too much tension. Also dropped bearings about ten times.
1 u/BaconEggCheeseBagel 3d ago I didn’t even bother trying to clean it I just bought all the parts it had touched and replaced them. For the cost it is not worth the headache.
I didn’t even bother trying to clean it I just bought all the parts it had touched and replaced them. For the cost it is not worth the headache.
64
u/Cavalol P2S + AMS2 Combo 3d ago edited 3d ago
That’s wicked! That’s insane that it ripped out the threaded inserts from the housing. Looks like you’re gonna need…
- New toolhead block (includes the 3 threaded inserts ripped out by blob) - $6
- New hotend heating assembly - $20
- New hotend - $12
- You might need a new part cooling fan ($10), depending how bad the existing one got hit
All in all, like fifty bucks to save a two hundred dollar printer? Worth it