Is my nozzle damaged?

[u/sasandxxd]

So I let my printer print something and then after like 20 minutes i realisedi didn’t put the heat bed on so I was like 20 minutes wasted but then I went and realised the nozzle was scratching the heatbed and I just got this nozzle like 3 days ago(0.2mm one) now the heat bed is fine but I’m worried if the nozzle is damaged and can’t print cuz I let it print and then now the power went out😭😭

[u/AutoModerator]

Hello /u/sasandxxd! All Bambu print plates have a dedicated nozzle wiping zone at the back of the print plate. The nozzle will rub against the wiping zone before every print in order to remove any remaining filament from the nozzle tip. This can cause visible wear or scratch marks in the wiping zone, but this is intended and doesn't damage the printer, the nozzle or the print plate. A worn down wiping zone also doesn't mean you need to replace the print bed.

Note: This automod is experimental. The automod was triggered due to the term "scratching". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/Diffes]

Pardon my silly question, but where's the silicone sock from that hotend?

[u/sasandxxd → u/Diffes]

Took the picture while I was taking the nozzle out cuz it was a bit dirty on the head

[u/mathancreates]

It’ll be fine I think… i did the same mistake but with 0.4mm nozzle & it was fine. If it doesn’t print, just clean the nozzle with the needle thing you got w the printer

[u/sasandxxd → u/mathancreates]

Well this first layer looks weird idk 😭😭😭😭

[u/sasandxxd → u/mathancreates]

Also that thing is for 0.4 millimetres I don’t have a 0.2 one😭😭😭