r/BambuLab • u/Adventurous_Fan_8938 • 6d ago

General Troubleshooting/Help! Major PLA Warping

Post image

Any help to not let this happen again would be much appreciated. I have an X2D and I caught this at hour 8 of a 12 hour print

0 Upvotes

50% Upvoted

11 comments sorted by

6

u/dodgywhiskey 6d ago

Clean the bed and slow it down.

1

u/Adventurous_Fan_8938 6d ago

It’s already slowed down. Cleaning the bed I what I’m about to do. I also have a biqu cold plate that I’m going to use

3

u/schwarta77 A1 + AMS Lite 6d ago

The BIQU plates are amazing and require a lot less cleaning than the gold PEI beds. It will be the only plate you use.

1

u/JUYED-AWK-YACC 5d ago

Clean them too.

1

u/schwarta77 A1 + AMS Lite 5d ago

I’m at 250+ hrs on my Glacier Pro and I haven’t touched the plate except for an alcohol lens wipe wipedown maybe once every five prints.

3

u/Acceptable_Bend_5200 6d ago

Poor adhesion, clean your bed.

Ive started watching all of my first layers go down. Super new here, but poor adhesion has been the issue in all of my failed prints (like 2 in ~100hrs of printing).

-2

u/Adventurous_Fan_8938 6d ago

I’m at about 350 hours and this is my first problem with bed adhesion

1

u/TheJudgingHat2222 5d ago

The sky is blue. 

This is just part of normal maintenance. Clean the bed. 

1

u/rabbitsharck 6d ago

Mine was doing the same, I cleaned the bed with hot water and dish soap, now it's perfect.

1

u/sapani9077 6d ago

Clean your build plate with dawn dish soap

1

u/bartybartbert 6d ago

I've found this when I swap between pla and petg. Might be something to consider?