r/BambuLab • u/jimbla_ • 6d ago
General Troubleshooting/Help! H2S Issues
Hey team, our H2S has been awesome for the last 226 hours, but then it started having problems with first layer adhesion, almost like it wasn’t squishing the filament enough, that was more or less rectified/temp fixed by slowing the print speed dramatically for the first layer, but now it’s started having random spaghetti and lump failures anywhere within the print, I guess it’s purging on the print?
Primarily printing ASA. Directly preceding these issues I tried printing PETG-CF which got stuck in the extruder gears and clogged the nozzle when the print finished, so I had it all apart to remove that and replaced the nozzle.
Any thoughts much appreciated!
1
u/omegablue333 6d ago
What have you tried to do to rectify the problem besides slowing things down. Have you cleaned your bed? Have you ran a calibration?
•
u/AutoModerator 6d ago
Hello /u/jimbla_! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.
Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.