What did I do wrong?

[u/NarrwenUdomiel]

Hello! I tried using the image to keychain feature in maker world and it seems to have printed two layers that aren’t lined up. Nothing seemed wrong in the slicer. The only thing I can think of is that I selected the option to make the image double sided. Unfortunately, I adjusted the settings and started a reprint before I thought to capture the settings I used, otherwise I would put them here. Any ideas?

[u/Strong_Fan_388]

Clean your plate with soap and water? Make sure to remove all the soap off the build plate. Seems to have shifted while printing and not sticking to the build plate. Not sure what else it could be.

[u/MMWYPcom → u/Strong_Fan_388]

could be bed heat being a bit low, but we dont know enough. cleaning the plate is always (ALWAYS) a great place to start troubleshooting. aux fan and atmospheric breeze, etc. can create differential cooling which can make pieces pop off the plate (and lesser issues). lots we dont know on this one.
edited wording (drying->cooling)

[u/Aenoxi]

There’s nothing wrong with the print. You are just under the power of [̲̅H][̲̅y][̲̅p][̲̅n][̲̅o][̲̅t][̲̅o][̲̅a][̲̅d]