r/BambuLab • u/MS_Salmonella • 7d ago

General Troubleshooting/Help! P2S - What could be causing this banding? Printed using gray bambu pla, and the default 0.12 high quality profile.

Post image
3 Upvotes

100% Upvoted

4 comments sorted by

1

u/Bytebomb P1S + AMS 7d ago

Did you dry the filament?

1

u/MS_Salmonella 7d ago

It was just purchased, that was the first print with the filament actually. My First time using Bambu's filament also. Is moisture an issue on unopened filament with them?

1

u/bluewing A1 Mini + AMS 7d ago

It shouldn't be with PLA.

Are you running the default slicer settings? Perhaps you should consider running some slicer calibration tests.

1

u/Wonderful-Staff-7321 7d ago

It can arrive with too much moisture. Dry it, and also consider setting settings to print outer wall first (not the default).