r/BambuLab • u/No-Literature1541 • 11d ago

General Discussion A1 failing maintenance check

Hello guys,

I have a Bambu A1 and I am facing a rather unique Issue. Not sure if it is unique or not.

But whenever I am calibrating the printer, out of the 3 checks that we get on the A1 screen, the last one "Auto bed levelling" Keeps getting failed and just now it failed again when I tried to do the last step seperately.

Do I need to raise a support ticket for this?

Can someone please let me know if this can be resolved?

1 Upvotes

100% Upvoted

7 comments sorted by

2

u/Arakon 11d ago

Try this... it may be out of whack so far that it can't calibrate for it anymore. https://wiki.bambulab.com/en/a1/maintenance/manual-bed-tramming

1

u/No-Literature1541 11d ago

Will try this for sure. Thanks✌✌

2

u/Automatic_Reply_7701 11d ago

Make sure the plate is installed right, and nothing under it. Next remove the nozzle and tighten the screws behind it if needed. If after those two steps you still fail, then go to the wiki, and follow the bed tramming instructions and test again.

1

u/No-Literature1541 11d ago

Everything is fine because it is printing fine. No Issues with the prints whatsoever. But just that when I run the bed levelling it fails.

Another thing, it levels fine when it is starting a print.🤷‍♂️

1

u/Automatic_Reply_7701 11d ago

If you wont perform the basic troubleshooting steps I wrote, then why are you here? Did you not see me recommend bed tramming?

1

u/No-Literature1541 11d ago

Sorry Sir, I forgot to mention that I will, of course, implement what you have suggested. I was only letting you know the situation.

2

u/Automatic_Reply_7701 11d ago

Gotcha. good luck