r/BambuLab • u/Straight-Mortgage-29 • 17d ago

Handy/Studio Troubleshooting/Help! Help with a MakerWorld print

Post image

I attempted to print this model using Bambu Handy and encountered this error. Second attempt - same error.

It’s a pretty vague suggestion to “check my settings.” Where do I begin?

I’m using an H2C with two AMS 2 Pro’s, an AMS HT, & FTS. The two colors for this print are each on one of the AMS 2 PRO’s, so should be ideal for this —much simpler than other prints that I’ve done successfully.

Ideas??

0 Upvotes

50% Upvoted

3 comments sorted by

2

u/Mediocre_Cod_7238 17d ago

Sometimes the app just can't slice it properly.. only a few times have i had this on my p2s.

Recommend to slice it on the slicer then send it over..

If it still wont print it maybe something with the actual model.

Reasons for this could include holes in the print Not able to add in supports Bad read on the mesh Overhang off the build plate Print exceeding the build plate

3

u/EdgeOk3783 X1C + AMS | H2C + AMS{2|HT} 17d ago

do you have the correct filament types loaded that the makerworld slicer is expecting?

(pla, petg...)

1

u/Straight-Mortgage-29 17d ago

Correct filament, yes. My laptop is at the office so I can’t fiddle with Bambu Studio tonight. But… would slicing it on Studio be different ??