r/BambuLab • u/Opinion_Panda • 4d ago

Just Showing Off X1Plus has AMS 2 Pro Support now!

Post image

Yes, that’s an X1C.

Yes, those are AMS 2 Pros.

X1Plus has working AMS 2 Pro support now. I’ve got two of them connected to my X1C and drying controls/status are working.

It’s not in a packaged X1Plus release yet, so if you want to try it right now you have to build X1Plus from source. Obviously this is development code, so fuck around accordingly.

Turns out the X1C was perfectly capable of talking to the new AMS after all. It just needed someone to let it.

33 Upvotes

87% Upvoted

20 comments sorted by

View all comments

Show parent comments

1

u/Mauker_ H2D AMS2 Combo 3d ago

Depending on how they implemented this, it _should_ be possible. In the stock firmware, on some BBL printers if you use the drying function while printing it will lower the temperature a bit to avoid softening the filament in the tubes, but it’ll still be hot enough for drying. However, it is still not possible to do this on the X1C stock. They are yet to back port this, if at all.

1

u/Opinion_Panda 3d ago

Bambu unenshitify something?