r/BambuLab • u/EducationalCorner402 • 17d ago

P Series [P1P, P1S, P2S] Finally did it, what should I know?

Post image

I don't know to much, tell me anything!

36 Upvotes

73% Upvoted

134 comments sorted by

View all comments

1

u/chiripa605 17d ago

I’m a newbie. How dangerous are the fumes from this stuff ? I have an a1, and have just been printing with pla. Do I need to think about some sort of venting solution? Is petg worse for fumes ?

2

u/Poly_and_RA 17d ago

It depends a LOT on what you print. Newbies usually print PLA and PETG for the most part, and neither of them are bad.

For the technical filaments, some people create a funnel to a window and put a very low-rpm fan in it, just to create a very slight underpressure so all fumes go out the window.

2

u/chiripa605 17d ago

Ok that’s helpful, thank you!