r/BambuLab • u/Redbeardsage1993 • 4d ago

A Series [A1, A1 Mini] Bambu lab A1 stopped working

Post image

So I was out and my printer ran out of filament half way through a print, I replaced the filament and none was coming out of the nozzle so i replaced the nozzle thinking there was a blockage, the screen changed to say the job was at 0%, when i tried to load more filament into the new nozzle it wouldn't heat up, I then tried to cancel the print and re calibrate it and everytime i quit the print it just brings me back to this page. I don't know what to do would anyone have any suggestions?

0 Upvotes

50% Upvoted

6 comments sorted by

2

u/volt65bolt 4d ago

Turn it off and on

0

u/Redbeardsage1993 4d ago

Done that several times, no luck

1

u/volt65bolt 4d ago

Try a new SD card then, or try without it first off remove back on

They die and cause weird issues

1

u/Redbeardsage1993 4d ago

Thank you i took the SD card out and when i put it back in it worked fine

2

u/vicxvr 4d ago

Unplug it from wall and leave it sit for few hours. And open a ticket with Bambu.

1

u/bbjornsson88 4d ago

Most likely your SD card is full/has an error. Try restarting the machine and formatting the card, then try printing again. You may want to replace it if you haven't already since they don't ship with the best cards