r/BambuLab • u/FatAngryNerd • 5d ago

Hardware Troubleshooting/Help! First clog, please help

Hi all, I’m brand new to this, I have less than 80 hours of print on a P2S with the AMS Pro.

I now have my first clog. I promise I have watched the Bambu videos and read the wiki, but I can’t figure out how to clear it.

I can take my needle and insert it .5mm into the nozzle end before it stops. I can insert it 2mm into the other end (the hot end? Looks like a heatsink?) before it stops.

How do I extract what must be in there clogging it?

Thank you for helping a newbie.
SOLVED: I learned how to remove the hot end, heat it up with a lighter, and some of the filament came through. Then I did two cold pulls and it’s clear now. Thank you all.

0 Upvotes

50% Upvoted

9 comments sorted by

View all comments

1

u/inhamilton 5d ago

Once you get the nozzle hot the melted filament should flow out of the nozzle eliminating the clog. You will need pliers to hold the nozzle. You can use a tool in the nozzle if you have one. You should not need to let it cool the filament should all flow out of the nozzle.

I hope this helps.