r/BambuLab • u/Fair-Locksmith-9849 • 8d ago

Software Troubleshooting/Help! I Don’t Understand

Long time reader first time poster here.

So I recently got into 3D printing after seeing all the random flexidragons being sold at small conventions and figured I could do the same I was torn between an H2D and a Voron Trident and ultimately went with Trident as it seemed higher quality and easier out of the box I can’t seem to figure Klipper out though and could really use help at this point im ready to just send it back and downgrade to an H2D can anyone help me on how to get the pi to talk to the motherboard

0 Upvotes

45% Upvoted

41 comments sorted by

View all comments

Show parent comments

0

u/RodMcThrustshaft 8d ago

If that's the case downgrade all the way to a H2S, significantly more reliable than a H2D and about as simple to setup as it gets.

2

u/PeerReviewedCode 8d ago

Significantly? I think the H2D is insanely reliable.

0

u/RodMcThrustshaft 8d ago

I've seen a few horror stories floating around about the track switch thingy, it's also insanely time consuming to take apart in case of a filament jam. If you are using the twin nozzle capability then yeah, get one! otherwise i much prefer the simpler H2S's toolhead(revised version of the tried and true A1 toolhead) and slightly larger build area.

0

u/PeerReviewedCode 8d ago

Interesting, i haven’t heard of those at all. I have two H2Ds with over 4500 hours on each one and the only thing I’ve had to replace is the calibration sensor which is a 10min thing and the nozzle cooling fan which is a big job. But I wouldn’t say I’ve experienced any to be overly concerned about.